返回首页

南阳电动伸缩门优质厂

本站导航

新闻动态

当前位置:网站首页 > 新闻动态 > 详细信息
机井房操作工艺
添加时间:2019/3/9 15:38:42     浏览次数:
砖砌体一般采用一顺一丁(满丁满条)梅花丁或三顺一丁砌合法砌筑。 排砖摞底 房屋外墙第一层砖撂底,一般两山墙排丁砖,前后纵墙排条砖。根据弹好门窗洞口位置线,认真核对窗间墙、垛的长度尺寸是否符合排砖模楼,如果窗间墙两个角是阴阳膀或不合排砖模楼。可将门窗口位置左右适当移动。若有破活、七分头或丁砖,应排在窗口中间、附墙垛旁或其它不明显的部位。另外,在排砖时,还要考虑在门窗口上边的砖墙合拢时不出现破活。 选砖 Brick
Brick masonry is usually built in accordance with the law of one-dimensional (full-strip) plum blossom or three-dimensional (three-dimensional) masonry. The first floor of the exterior wall of a brick-row and bottom-stacked house is the bottom of the brick. Generally, two Gables are lined with bricks, and the front and rear longitudinal walls are lined with bricks. According to the position line of the door and window openings, carefully check whether the length and size of the window walls and stacks conform to the brick-row building, if the two corners of the window walls are Yinyang or not. The position of the door and window can be properly moved from left to right. If there are broken, segmented or spun bricks, they should be placed in the middle of the window, beside the wall stack or other obscure parts. In addition, when arranging bricks, we should also consider that the brick walls above the doors and windows do not appear to be broken when they are closed. Brick selection Brick
选择棱角整齐、无弯曲裂纹、颜色均匀、规格基本一致的砖;敲击时声音响亮的砖强度高,声哑的砖强度低。由于焙烧过火而造成变色形,但强度较高的砖,可用在基础及不影响外观的内墙上。 盘角 砌墙前应先盘角,但每次盘角不要超过五层,新盘的大角,及时进行吊靠,如有偏差要及时修理。盘角时要认真对照皮数杆的砖层和标高,水平灰缝要均匀一致。大角盘好后再检查一次,平整和垂直完全符合质量要求才可以挂线砌墙。 Select bricks with neat edges, no bending cracks, uniform colors, and basic specifications. The brick that the sound is loud and loud, the brick strength is low. Because the roasting fire causes the color of the color, but the high strength brick can be used on the foundation and the inner wall that does not affect the appearance. The Angle of the plate should be set before the corner of the wall, but no more than five floors in each corner, the large Angle of the new plate, and the time of the suspension, if the deviation should be repaired in time. The brick layer and the elevation of the leather number rod should be carefully controlled in the corner, and the horizontal grey seam should be uniform. After the big Angle plate is good, check once again, level and vertical completely accord with quality requirement to be able to hang line wall.

Bricks with neat edges and corners, no bending cracks, uniform color and basically the same specifications are selected. Bricks with loud sound have high strength and dumb bricks have low strength when struck. Bricks with high strength can be used on foundations and interior walls which do not affect the appearance because of the discoloration caused by excessive roasting. Before building a wall with pan corners, the pan corners should be made first, but each time the pan corners should not exceed five floors. The large corners of the new pan should be lifted in time and repaired in time if there are any deviations. When disc angle, the brick layer and elevation of the pitch bar should be carefully compared, and the horizontal grey joint should be uniform and consistent. After the big angle plate is finished, check again, and the level and vertical completely meet the quality requirements before the wall can be wired. Select bricks with neat edges, no bending cracks, uniform colors, and tianchuangd.89ix.comtianchuang.89ix.comtongfengqiw.89ix.comtongfengqi.89ix.comchuanxian.89ix.com

pvcguanjian.89ix.combasic specifications. The brick that the sound is loud and loud, the brick strength is low. Because the roasting fire causes the color, but the high strength brick can be used on the foundation and the inner wall that does not affect the appearance. The Angle of the appearance. Plate should be set before the corner of the wall, but no more than five floors in each corner, the large Angle of the new plate, and the time of the suspension, if the deviation should be repaired in time. The brick layer and the elevation of the leather number rod should be carefully controlled in the corner, and the horizontal grey seam should be carefully controlled. After the big Angle plate is good, check once again, level and vertical completely accord with quality requirements to be able to hang line wall.

上一页  玻璃钢井房有什么优势?  
下一页  智能井房产品特点
  • 关于我们
  • 新闻动态
  • 案例展示
  • 网上订单
  • 联系我们
  • 产品分类1
  • 产品分类2
  • 产品分类3

Copyright © 技术支持:遨游网络

  • 联系我们
  • 网上订单
  • 工程案例
  • 本站导航

搜索

  • 关于我们
  • 新闻动态
  • 案例展示
  • 网上订单
  • 联系我们
  • 产品分类1
  • 产品分类2
  • 产品分类3