南阳电动伸缩门优质厂

基层处理：基层表面的尘土、脏物事先清扫或铲除，基层含水率不得大于10%。  刮腻子：腻子随用随调，一次调配的数量最多不得超过2d，在找补腻

Grassroots treatment: dust and dirt on the base surface are cleaned or removed in advance, and the moisture content of the base shall not be greater than 10%. Putty putty: in tune with the times, a deployment of the largest number of not more than 2D, in any greasy

子时，对孔缝深的应分二次或三次补平，待腻子干透后，用砂纸打磨光滑即可涂刷涂料。  刷涂料：涂刷涂料的施工温度应按产品说明的要求控制，防止冻结。涂刷前，先将涂料搅拌均匀，如感太稠，可以加水稀释，但加水量不应超过20%， 涂刷涂料用排笔涂刷，从一头开始，顺着逐渐刷向另一头，每个刷面应一次完成，以避出现接头。第一遍涂料刷过之后，遇有局部透底，厚薄不均，不能用补点方法处理，必须满刷一遍才能保证色泽一致。最后一遍涂料要一笔一笔挨着刷直，不得成弧形，做到刷纹顺直、厚薄均匀、不显接砂、无流坠、溅沫、透底等质量问题。涂刷遍数应根据颜色深浅和涂料遮盖力情况确定，至少三遍。

When the hole of the Fengshen should be divided into two or three flat, until the putty is dry, sanding smooth coating can be painted. Brush paint: paint coating construction temperature should be controlled according to the requirements of the product to prevent freezing. The first coating, paint mixing, such as being too thick, can be diluted with water, but water should not exceed 20%, brushed by brush coating paint, start from one end to another, gradually along the brush head, each brush surface should be finished at the same time, in order to avoid the emergence of joint. After the paint brush, in part through the end, uneven thickness, cannot be used to supplement treatment, must be brush to ensure consistent color. The last time to paint a sum to brush straight, not curved, do brush straight, uniform thickness, no significant ground sand, no flow drop, splash, and other quality problems through the end. Brushing number should be based on the color depth and paint hiding force to determine, at least three times.