机井房施工 ⑴、轴线测量：根据机井点位，计算出建筑物的轴线控制线，并在现场设立井字轴线控制网，使用T2型经纬仪采用借线法引测出各轴线。  ⑵、 施工顺序  本工程按先地下后地上，工期长的工程先施工，工期短的工程按资源优化和工艺要求的原则适时插入，先主体后装修，门窗工程安装穿插作业的基本顺序组织施工。建立成品保护措施，合理安排施工顺序，避免返工损失。  ⑶、砌体工程 准备工作  砌筑前应完成房心回填，按标高抹好水泥砂浆防潮层；弹好墙身线、轴线，并根据现场砖的实际规格尺寸，再弹出门窗洞口位置线，经验线符合设计图纸的尺寸要求，办完预检查手续；按标高立好皮数杆，皮数杆的间距以1.5––2.0米为宜。  常温施工时，粘土砖必须在砌筑前一天浇水湿润，一般以水浸入砖四边1.5厘米为宜，不得用干砖砌墙；冬季施工时（上午十时至下午三时），在晴天无风的条件下。应用喷壶用适用温水浇砖，随浇随砌，以提高砌体抗剪强度。 Shaft housing construction (1), axis measurement: according to the lifting point, calculate the axis line of the building, and on the spot to set up the tic-tac-toe axis control network, using the type T2 theodolite by line method is used to measure each axis. [2] the construction sequence, the project according to the underground on the ground after the first, time limit for a project long engineering construction first, short time limit of project, based on the principles of resource optimization and technological requirements of timely and insert, the subject before decorate, doors and Windows engineering installation work the basic order of organization construction. Establish the product protection measure, arrange the construction sequence reasonably, avoid the rework loss. In the preparation of the construction of the construction work, the core of the building should be completed before the construction of the building. Play wall body axis line, and according to the actual size of the brick, pop-up Windows and doors hole position line again, experience line can meet the demands of the size of the design drawings, and completed preliminary inspection procedures; According to the height of the leather number pole, the distance between the leather rods is 1.5-2.0m. In the construction of ordinary temperature, clay bricks must be watered the day before masonry. During the winter construction (10 am to 3 PM), the weather is not windy. The application of the spray pot is used to water the bricks in warm water, with the water on the water, to improve the shear strength of masonry.